Welcome to My Blog!

This is Boxer Template Demo Site
Follow Me

ROSAT re-entry



By  Unknown     7:07 PM     
During its mission, the ROentgen SATellite (ROSAT) performed its observations in an elliptical orbit at distances of between 585 and 565 kilometres above the surface of the Earth. Since its decommissioning, atmospheric drag has caused the satellite to lose altitude. In June 2011, it was at a distance of only about 327 kilometres above the ground. Due to the fact that ROSAT does not have a propulsion system on board, it was not possible to manoeuvre the satellite to perform a controlled re-entry at the end of its mission in 1999. When the spacecraft re-enters the atmosphere at a speed of approximately 28,000 kilometres per hour, the X-ray observatory will break up into fragments, some of which will burn up by the extreme heat. The latest studies reveal that it is possible that up to 30 individual pieces weighing a total of 1.7 tons may reach the surface of the Earth. The largest single fragment will probably be the telescope's mirror, which is very heat resistant and may weigh up to 1.7 tons.


The time and location of re-entry cannot be predicted precisely. At present, scientists expect the X-ray satellite, which completes an orbit around Earth in about 90 minutes, to re-enter around between 21 and 24 October 2011. Currently, the re-entry date can only be calculated to within plus/minus two days. This time slot of uncertainty will be reduced as the date of re-entry approaches. However, even one day before re-entry, the estimate will only be accurate to within plus/minus five hours .All areas under the orbit of ROSAT, which extends to 53 degrees northern and southern latitude could be affected by its re-entry. The bulk of the debris will impact near the ground track of the satellite. However, isolated fragments could fall to Earth in a 80 kilometre wide path along the track.

About Unknown

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Maecenas euismod diam at commodo sagittis. Nam id molestie velit. Nunc id nisl tristique, dapibus tellus quis, dictum metus. Pellentesque id imperdiet est.

No comments:

Post a Comment


Contact Form

Name

Email *

Message *

Translate

Social Pages